nah i mean how do the reed petals themselves mount into the reed block, it looks like they just clamp into it instead of bolt on? reckon you could measure em up height and width wise? i might start mounting up a set to this 620

the reed block is a mad set up it just clicks together and holds the petals in place, measurements are 41mm wide 41mm high and it penetrates in to the crank case by 40mm

What ever happened to that photo of your dream bike in half from indy??? Just a thought

	Teatime wrote:
	What ever happened to that photo of your dream bike in half from indy??? Just a thought

Id almost forgotten about that feat of engineering…. pretty sure that was about the time when Rodney’s face was also on the side of his car……too many confusion.

u got nuthin

	Teatime wrote:
	u got nuthin

i got nuthin" but i kicked your ass last race meet, hehehe.

oh i also have droped 0.6 off my quickest time at wrc , i owe this to the reeds and jet change, i have better acceleration out of the corners.

on some uk forum from the importer of KO stuff with regards to the reeds -

KO V Force Reed Cage

I've done some brief testing of the KO V Force Reed cage this week on Lewis's OR Super. The improvement to midrange is quite incredible.

The torque output and HP is phonomenal for the RPM at which it occurs. Not gonna talk facts and figures but these things are worth every penny.

KO V Force Reed Cage @ 75 GBP

KO V Force Reed Cage fitted including parts and bottom end re-build @139.95 GBP (Supers only......porting required to BZM/Polini cases)

Glen wrote:

on some uk forum from the importer of KO stuff with regards to the reeds - KO V Force Reed Cage I've done some brief testing of the KO V Force Reed cage this week on Lewis's OR Super. The improvement to midrange is quite incredible. The torque output and HP is phonomenal for the RPM at which it occurs. Not gonna talk facts and figures but these things are worth every penny. KO V Force Reed Cage @ 75 GBP KO V Force Reed Cage fitted including parts and bottom end re-build @139.95 GBP (Supers only......porting required to BZM/Polini cases)

In stock.

Only registered users can see links on this forum! Register or Login on forum!

Very nice, Do those reed blocks bolt onto a Polini Bizeta etc?? or are mods needed??

i tink you need to do a little porting to fit them in

They will fit Polini and BZM cases, but you need to cut the reed are out by around 1mm to fit them.
They are the same bolt pattern.

Are there any real proven gains at this stage as compaired to say polini reeds??
And how much are we looking at for a set with manifold etc??

chris you can run your manifold , think about it this way, the reeds only have to open half as far to receive the same volume of air/fuel mix, thus minimising the time needed to close and open, allowing just a fraction more airfuel into the crankcase, not back out the carby, this slightly increases your crank compression, which allows more airfuel into the combustion chamber, which increases the compression, which gives a bigger bang, but it wont help on your bike so dont get one ah you better get one than you might beat spooky, and than may be able to have a crack at al, than if you can get past him you can have a crack at beating ME